SHIFT LEVER ASSEMBLY INSTALLATION

PROCEDURE


  1. INSTALL FLOOR SHIFT LEVER ASSEMBLY


    1. A004N6V

      Attach the 2 claws to connect the shift control cable and select control cable to the shift lever assembly.

    2. A004OZ1

      Connect the end of the shift control cable to the shift lever assembly and install the clip.

    3. A004R5Y

      Install the shift lever assembly with the 4 bolts.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }
    4. A004U1B

      Attach the 3 wire harness clamps.

    5. Release the lock of the cable length adjustment structure of the select cable.


      1. A004RNBE02
        Text in Illustration
        *1 Stopper
        *a Twist

        Twist the stopper.

      2. A004NMOE06
        Text in Illustration
        *1 Lock Piece
        *2 Case
        *a Pull out

        Pull the lock piece outward from the case to release the lock.

    6. A004P87E03

      Pressing the shift and select lever shaft (*1) and pin (*2), push in pin (*3) and check that the shift and select lever shaft is secured at the 1st-2nd gear selected position (the shaft comes to a stop at the position 8 mm (0.315 in.) below the N position).

    7. A004S38

      Connect the end of the select control cable to the shift lever assembly and install the clip.

      Note


      • Make sure the lock piece of the select control cable is facing upward when the select control cable is connected.

      • Make sure the clip is inserted in the direction shown in the illustration.

    8. A004MWPE02
      Text in Illustration
      *1 Slider
      *2 Inhibitor Wall

      Push the slider against the inhibitor wall.

      Note


      • Do not pull up the slider.

      • When adjusting the cable, make sure that the shift lever is not in 1 or 2.

    9. Lock the cable length adjustment structure of the select cable.


      1. A004O2XE04
        Text in Illustration
        *1 Lock Piece
        *2 Case
        *a Push

        Push the lock piece into the case with slider held against the inhibitor wall.

      2. A004NXIE02
        Text in Illustration
        *1 Stopper
        *2 Return

        Return the stopper to prevent the lock from being released.

        Note


        • Push in the lock piece completely.

        • Make sure that the cable length adjustment structure is locked securely.

    10. A004NSN

      Release the pin that fixes the shift and select lever shaft.


      1. Pull the pin toward the left front side of the vehicle.

        Text in Illustration
        A004NPW Pull

  2. INSTALL CONSOLE BOX ASSEMBLY

    w/ Console Box Lid: Click here

    w/o Console Box Lid: Click here