TRANSMISSION CONTROL CABLE ADJUSTMENT

PROCEDURE


  1. ADJUST TRANSMISSION CONTROL SELECT CABLE

    Tech Tips


    • After the shift lever or the shift cable is replaced, be sure to adjust the transmission control cable assembly.

    • If the shift lever does not move (or the shift lever is difficult to move) to 1st or 2nd or if it is possible to move the shift lever to reverse without pulling up the slider shaft, the length of the cable must be adjusted.


    1. Disconnect the select control cable from the shift lever assembly.

    2. Release the lock of the cable length adjustment structure of the select cable.


      1. A004RNBE02
        Text in Illustration
        *1 Stopper
        *a Twist

        Twist the stopper.

      2. A004NMOE05
        Text in Illustration
        *1 Lock Piece
        *2 Case
        *a Pull out

        Pull the lock piece outward from the case to release the lock.

    3. A004P87E03

      Pressing the shift and select lever shaft (*1) and pin (*2), push in pin (*3) and check that the shift and select lever shaft is secured at the 1st-2nd gear selected position (the shaft comes to a stop at the position 8 mm (0.315 in.) below the N position).

    4. Install the control select cable to the shift lever assembly.

    5. A004MWPE02
      Text in Illustration
      *1 Slider
      *2 Inhibitor Wall

      Push the slider against the inhibitor wall.

      Note


      • Do not pull up the slider.

      • When adjusting the cable, make sure that the shift lever is not in 1 or 2.

    6. Lock the cable length adjustment structure of the select cable.


      1. A004O2XE04
        Text in Illustration
        *1 Lock Piece
        *2 Case
        *a Push

        Push the lock piece into the case with slider held against the inhibitor wall.

      2. A004NXIE02
        Text in Illustration
        *1 Stopper
        *a Return

        Return the stopper to prevent the lock from being released.

        Note


        • Push in the stopper completely.

        • Make sure that the cable length adjustment structure is locked securely.

    7. A004NSN

      Release the pin that fixes the transmission outer lever.

      Text in Illustration
      A004NPW Pull

      1. Pull the pin toward the left front side of the vehicle.