ATF TEMPERATURE SENSOR INSTALLATION

PROCEDURE


  1. INSTALL ATF TEMPERATURE SENSOR ASSEMBLY

    A004UBZE09
    Text in Illustration
    *1 New O-ring

    1. Coat a new O-ring with ATF and install it to the ATF temperature sensor.

    2. Coat the 4 bolts with ATF.

    3. A004TG1E02
      Text in Illustration
      *1 Clamp

      Install the ATF temperature sensor and clamp to the valve body with the 4 bolts.

      Torque:
      11 N*m  { 110 kgf*cm, 8 ft.*lbf }

      Tech Tips

      Each bolt length is indicated below.

      Bolt A: 25 mm (0.984 in.)

      Bolt B: 85 mm (3.35 in.)

    4. Connect the connector.

  2. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

    Click here

  3. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

    Click here

  4. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT LH

    Click here

  5. ADD AUTOMATIC TRANSAXLE FLUID


    1. Add automatic transaxle fluid (See page AUTOMATIC TRANSMISSION / TRANSAXLE (U660E) > AUTOMATIC TRANSAXLE FLUID > ADJUSTMENT).

  6. INSTALL REAR ENGINE UNDER COVER LH


    1. Install the rear engine under cover LH with the 5 clips.

  7. INSTALL NO. 1 ENGINE UNDER COVER


    1. Install the engine under cover with the 11 clips.

  8. INSTALL FRONT LOWER BUMPER ABSORBER


    1. Insert the 2 hooks of the front lower bumper absorber into the installation holes on the body to install the front lower bumper absorber.

    2. Install the 8 bolts.

    3. Install the 2 clips.