LANE-KEEPING ASSIST SYSTEM, Diagnostic DTC:C1A05

DTC Code DTC Name
C1A05 Stop Light Switch Circuit

DESCRIPTION

When the brake pedal is depressed, the stop light switch sends a signal to the driving support ECU via the ECM. After receiving the signal, the driving support ECU cancels the lane-keeping assist system.

DTC Code DTC Detection Condition Trouble Area
C1A05 The voltages of terminals ST1- and STP of the ECM are both below 1 V for 0.5 seconds or more.

  • Stop light switch

  • CAN communication system

  • ECM

  • Driving support ECU

WIRING DIAGRAM

A004MR8E02

PROCEDURE


  1. CHECK FOR DTC (DYNAMIC RADAR CRUISE CONTROL SYSTEM)


    1. Check for DTCs Click here.

      OK
      DTC P0571 is not output.

    NG

    GO TO DYNAMIC RADAR CRUISE CONTROL SYSTEM Click here

    OK

  2. CHECK CAN COMMUNICATION SYSTEM


    1. Select "Bus Check" from the "System Select" screen on the intelligent tester.

    2. Select "Communication Malfunction DTC" from the "Bus Check" screen, and then select "Enter".

      Result
      Result Proceed to
      CAN DTC is not output A
      CAN DTC is output B

    B

    GO TO CAN COMMUNICATION SYSTEM Click here

    A

  3. REPLACE DRIVING SUPPORT ECU


    1. for LHD:

      Replace the driving support ECU Click here.

    2. for RHD:

      Replace the driving support ECU Click here.


    NEXT

  4. CHECK FOR DTC


    1. Clear the DTCs Click here.

    2. Check for DTCs Click here.

      OK
      DTC C1A05 is not output.

    OK

    END (DRIVING SUPPORT ECU IS DEFECTIVE)

    NG

    REPLACE ECM Click here