DATA LIST
Tech Tips
Using the intelligent tester to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Note
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Cruise Control*1 or Radar Cruise*2 / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| ASL Vehicle Speed | Vehicle speed / Min.: 0 km/h (0 mph), Max.: 255 km/h (159 mph) | Actual vehicle speed displayed | - |
| ASL Memory Vehicle Speed | Vehicle speed / Min.: 0 km/h (0 mph), Max.: 255 km/h (159 mph) | Vehicle speed stored in memory | - |
| ASL Throttle Position | Throttle opening angle / Min.: 0%, Max.: 100% | Actual required throttle opening amount | - |
| ASL Ready | Speed limit standby condition / ON or OFF | ON: Warning canceling switch on OFF: Warning canceling switch off |
- |
| ASL Main Switch | Warning canceling switch signal / ON or OFF | ON: Warning canceling switch on OFF: Warning canceling switch off |
- |
| ASL Shift Position Request | Transaxle gear request signal/ Min.: 0, Max.: 8 | Required transaxle gear | - |
*1: w/o Dynamic Radar Cruise Control System
*2: w/ Dynamic Radar Cruise Control System
ACTIVE TEST
Tech Tips
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other item to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter following menus: Body / Combination Meter / Active test.
According to the display on the intelligent tester, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Indicat. ASL | Speed limiter indicator light | ON/OFF | - |