CRUISE CONTROL SYSTEM TC and CG Terminal Circuit

WIRING DIAGRAM

A004TD9E02

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (DLC3 - ECM AND BODY GROUND)

    A004U2RE02
    Text in Illustration
    *1 Front view of DLC3
    *2

    Front view of wire harness connector

    (to ECM)

    1. Disconnect the A40 ECM connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      D8-13 (TC) - A40-26 (TC) Always Below 1 Ω
      D8-4 (CG) - Body ground
      D8-13 (TC) - Body ground Always 10 kΩ or higher

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR