STARTER(for DENSO Made) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

  4. REMOVE NO. 1 ENGINE COVER

    Click here

  5. REMOVE RADIATOR SUPPORT OPENING COVER

    Click here

  6. REMOVE BATTERY CLAMP SUB-ASSEMBLY


    1. A004TN8

      Remove the bolt and loosen the nut.

    2. Detach the hook of the battery clamp from the battery carrier, and then remove the battery clamp.

  7. REMOVE BATTERY INSULATOR

  8. REMOVE BATTERY

  9. REMOVE BATTERY TRAY

  10. REMOVE BATTERY CARRIER


    1. A004SBN

      Detach the 2 clamps and disconnect the wire harness.

    2. Remove the 4 bolts and battery carrier.

  11. DISCONNECT NO. 2 VACUUM TRANSMITTING HOSE ASSEMBLY


    1. A004SW6

      Disconnect the No. 2 vacuum transmitting hose from the intake manifold.

  12. REMOVE NO. 3 AIR HOSE

    Click here

  13. REMOVE STARTER ASSEMBLY


    1. A004TOS

      Disconnect the starter connector.

    2. Open the terminal cap, remove the nut and disconnect the starter wire.

    3. A004U1T

      Remove the 2 bolts and starter.