EXHAUST GAS TEMPERATURE SENSOR(for Sensor 1) REMOVAL

PROCEDURE


  1. REMOVE NO. 1 ENGINE COVER

    Click here

  2. DISCONNECT VACUUM CONTROL VALVE BRACKET


    1. A004Q6A

      Disconnect the exhaust gas temperature sensor connector.

    2. Detach the wire harness clamp.

    3. A004TUBE02
      Text in Illustration
      *a Air Fuel Ratio Sensor Connector
      *b Exhaust Gas Temperature Sensor Connector
      *c Clamp

      Disconnect the exhaust gas temperature sensor connector.

    4. Disconnect the air fuel ratio sensor connector.

    5. Raise the air fuel ratio sensor connector from the vacuum control valve bracket.

    6. Move the clamp as shown in the illustration, and disconnect the air fuel ratio sensor and exhaust gas temperature sensor.

      Note

      Disconnect the sensors while opening the clamp.

    7. Detach the air fuel ratio sensor clamp from the vacuum control valve bracket.

    8. A004MT6

      Using a T20 "TORX" socket wrench, remove the 3 screws and disconnect the vacuum control valve bracket.

  3. REMOVE NO. 1 TURBO INSULATOR


    1. A004TIT

      Remove the 3 bolts, nut and No. 1 turbo insulator.

  4. REMOVE EXHAUST GAS TEMPERATURE SENSOR (for Sensor 1)

    Note

    If the exhaust gas temperature sensor is dropped, replace it with a new one.


    1. A004OTE

      Using a 14 mm union nut wrench, remove the exhaust gas temperature sensor.