EXHAUST GAS TEMPERATURE SENSOR INSTALLATION

PROCEDURE


  1. INSTALL EXHAUST GAS TEMPERATURE SENSOR (for Upper Side)

    Note

    If the sensor is dropped, replace it with a new one.


    1. A004S6L

      Using a 14 mm union nut wrench, install the sensor.

      Torque:
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }

      Note

      Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Click here.

    2. Attach the sensor connector clamp.

  2. INSTALL EXHAUST GAS TEMPERATURE SENSOR (for Lower Side)

    Note

    If the sensor is dropped, replace it with a new one.


    1. A004R8EE03
      Text in Illustration
      *1 White Tube
      *2 Protective Tube

      Temporarily install the sensor with the union nut.

    2. Attach the sensor connector clamp.

    3. Temporarily install the clamp with the nut.

      Note

      Make sure the clamp is aligned with the white tube of the wire harness as shown in the illustration.

    4. Tighten the nut.

      Torque:
      6.4 N*m  { 65 kgf*cm, 57 in.*lbf }

    5. Using a 14 mm union nut wrench, tighten the union nut of the sensor.

      Torque:
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }

      Note


      • When tightening the union nut, make sure that the protective tube of the sensor is within the range shown in the illustration.

      • Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Click here.

  3. INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY

    Click here

  4. INSTALL NO. 1 MANIFOLD CONVERTER INSULATOR

    Click here

  5. INSTALL ENGINE ASSEMBLY

    Click here