FUEL SENDER GAUGE ASSEMBLY INSPECTION

PROCEDURE


  1. INSPECT FUEL SENDER GAUGE ASSEMBLY

    A004TOME01
    Text in Illustration
    *a

    Component without harness connected

    (Fuel Sender Gauge Assembly)
    *b F (Upper)
    *c E (Lower)

    1. Check that the float moves smoothly between F and E.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 2 Float level is F (upper) 13.5 to 16.5 Ω
      Float level is E (lower) 405.5 to 414.5 Ω

      If the result is not as specified, replace the fuel sender gauge assembly.