CYLINDER HEAD GASKET REMOVAL

CAUTION / NOTICE / HINT

Note


  • After the engine has stopped, wait at least 1 minute before releasing the high pressure lines.

  • When working on the fuel circuit, protect the generator assembly against dirt contamination.

    Cover the generator assembly with suitable materials.

    Failure to comply with this procedure may result in a generator assembly malfunction.

  • A004OHTE01

    After disconnecting the pressure line, it is absolutely essential to seal the injector assemblies and the common rail assembly with SST.

    SST
    PZ4TB-04941-79

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE CAMSHAFT AND NO. 2 CAMSHAFT

    Click here

  4. REMOVE EXHAUST MANIFOLD

    Click here

  5. REMOVE EGR VALVE BRACKET

    Click here

  6. REMOVE NO. 2 TURBO INSULATOR

    Click here

  7. DISCONNECT RADIATOR RESERVOIR ASSEMBLY


    1. A004NCG

      Remove the 2 bolts and disconnect the radiator reservoir assembly.

  8. REMOVE ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH


    1. A004MXS

      Detach the clamp to disconnect the air conditioner tube and accessory assembly.

    2. Detach the 2 clamps to disconnect the suction pipe sub-assembly.

    3. A004SYDE01
      Text in Illustration
      *a Wooden Block

      Place a wooden block between a jack and the oil pan sub-assembly.

    4. Support the engine slightly.

    5. A004PIY

      Remove the 4 bolts, 3 nuts and engine mounting insulator sub-assembly RH.

      Tech Tips

      Supporting the engine slightly makes the engine mounting insulator sub-assembly RH easier to remove.

  9. REMOVE GLOW PLUG ASSEMBLY

    Click here

  10. REMOVE CYLINDER HEAD SUB-ASSEMBLY


    1. A004O9X

      Using an E10 "TORX" socket wrench, remove the 5 bolts.

    2. A004N99E09

      Using an E18 "TORX" socket wrench, uniformly loosen the 10 cylinder head bolts in several steps in the sequence shown in the illustration.

      Note

      Do not reuse the cylinder head bolt.

    3. Remove the 10 cylinder head bolts and cylinder head sub-assembly.

  11. REMOVE CYLINDER HEAD GASKET