REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL REAR ENGINE OIL SEAL


    1. A004OOGE03

      Using SST, tap in a new rear engine oil seal until its surface is flush with the rear oil seal retainer edge.

      SST
      09608-36010
      09950-70010   ( 09951-07100 )

      Note

      Do not tap the rear engine oil seal at an angle.

  2. INSTALL FLYWHEEL WITH DAMPER ASSEMBLY


    1. Install the crankshaft position sensor plate to the crankshaft.

    2. Temporarily install the flywheel with damper assembly with 8 new bolts.

    3. A004U79E03

      Using SST, fix the flywheel with damper assembly.

      SST
      PZ4TB-04939-38
    4. A004OWDE01

      Using SST, tighten the 8 bolts.

      SST
      PZ4TB-04910-18
      Torque:
      120 N*m  { 1224 kgf*cm, 89 ft.*lbf }

    5. Remove SST.

  3. INSTALL CLUTCH DISC ASSEMBLY

    Click here

  4. INSTALL CLUTCH COVER ASSEMBLY

    Click here

  5. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY

    Click here

  6. INSTALL MANUAL TRANSAXLE ASSEMBLY

    Click here