REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL REAR CRANKSHAFT OIL SEAL


    1. Apply MP grease to the lip of a new oil seal.

    2. A004QCFE01

      Using SST and a hammer, tap in the oil seal as shown in the illustration.

      SST
      09223-56010
      Standard depth
      0 to 0.9 mm (0 to 0.0354 in.)

      Note


      • Keep the lip free from foreign matter.


      • Do not tap the oil seal at an angle.


      • Make sure that the oil seal is properly installed.

  2. INSTALL FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)

    Click here

  3. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transaxle)

    Click here

  4. INSTALL CLUTCH DISC ASSEMBLY (for Manual Transaxle)

    Click here

  5. INSTALL CLUTCH COVER ASSEMBLY (for Manual Transaxle)

    Click here

  6. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY (for Manual Transaxle)

    Click here

  7. INSTALL MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)


    1. Install the manual transaxle Click here.

  8. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle)


    1. Install the automatic transaxle Click here.

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.