REAR CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)


    1. Remove the manual transaxle Click here.

  4. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle)


    1. Remove the automatic transaxle Click here.

  5. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle)

    Click here

  6. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle)

    Click here

  7. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)

    Click here

  8. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transaxle)

    Click here

  9. REMOVE REAR CRANKSHAFT OIL SEAL


    1. A004N1PE01
      *1 Cut Position

      Using a knife, cut off the lip of the oil seal.

    2. Using a screwdriver, pry out the oil seal.

      Note

      Be careful not to damage the crankshaft.