AIR FUEL RATIO SENSOR(for Sensor 1) INSTALLATION

PROCEDURE


  1. INSTALL AIR FUEL RATIO SENSOR


    1. A004SO3E02
      Text in Illustration
      *a Fulcrum Length

      Using SST, install the air fuel ratio sensor.

      SST
      09224-00011
      Torque:
      Specified tightening torque
      50 N*m  { 510 kgf*cm, 37 ft.*lbf }

      Note

      If an air fuel ratio sensor has been struck or dropped, replace it.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench Click here.

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)): 45 N*m (456 kgf*cm, 33 ft.*lbf)

    2. A004MZ1E02
      Text in Illustration
      *1 Air Fuel Ratio Sensor Connector
      *2 Bracket
      *a 1.5 mm (0.0591 in.) or less

      Lower the air fuel ratio sensor connector to the position shown in the illustration and connect the air fuel ratio sensor connector.

    3. Attach the 2 clamps.

  2. INSPECT FOR EXHAUST GAS LEAK

    Click here

  3. INSTALL NO. 1 ENGINE COVER

    Click here

  4. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY

    Click here

  5. REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY

    Click here

  6. PERFORM INITIALIZATION

    Click here