ECD SYSTEM, Diagnostic DTC:U1500

DTC Code DTC Name
U1500 OMI Not Initialized

DESCRIPTION

The ECM outputs this DTC when OMI (Oil Maintenance Interval) initialization is not performed.

DTC No. DTC Detection Condition Trouble Area
U1500

OMI (Oil Maintenance Interval) initialization is not performed.

(1 trip detection logic)


  • CAN malfunction system

  • ECM

Tech Tips

Normally, the ECM automatically initializes the OMI value and performs learning within a couple of seconds after the ignition switch is turned to ON.

CAUTION / NOTICE / HINT

Note

When replacing the ECM, the ECM needs Registration and Initialization Click here.

Tech Tips


  • When the ECM must be replaced, before replacing the ECM, perform the "Learning Values Save" function using the GTS. Then after installing the new ECM, perform all of the initialization/registrations for the "Learning Values Write" function by following the instructions shown on the GTS display.

  • Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

PROCEDURE


  1. READ VALUE USING GTS (OIL MAINTENANCE INTERVAL)


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS on.

    3. Enter the following menus: Powertrain / Engine and ECT / Data List / Oil Maintenance Interval.

    4. Start the engine.

    5. Read the value.

      Result
      Result Proceed to
      Not Initialized A
      Short OMI or Long OMI B

    B
    A
  2. CHECK WHETHER DTC OUTPUT RECURS


    1. Check if CAN malfunction DTCs related to the main body ECU are output Click here.

      Result
      Result Proceed to
      No DTC output A
      DTC output B

    B
    A
  3. CHECK WHETHER DTC OUTPUT RECURS (DTC U1500)


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS on.

    3. Clear the DTCs Click here.

    4. Turn the ignition switch off and wait for 60 seconds or more [A].

    5. Perform road test [B].

    6. Repeat [A] and [B] for the number of trips detected.

    7. Enter the following menus: Engine and ECT / Trouble Codes.

    8. Confirm that the DTC is not output again.

      Result
      Result Proceed to
      DTC U1500 A
      No DTC output B

    B
    A
  4. REPLACE ECM


    1. Replace the ECM Click here.


    NEXT
  5. CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS on.

    3. Clear the DTCs Click here.

    4. Turn the ignition switch off and wait for 60 seconds or more [A].

    5. Perform road test [B].

    6. Repeat [A] and [B] for the number of trips detected.

    7. Enter the following menus: Engine and ECT / Trouble Codes.

    8. Confirm that the DTC is not output again.


    NEXT