ECM REMOVAL

PROCEDURE


  1. PERFORM REGISTRATION

    Click here

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE NO. 1 ENGINE COVER

    Click here

  5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A004SZB

      Disconnect the mass air flow meter connector and detach the wire harness clamp.

    2. Detach the 2 clamps.

    3. Loosen the hose clamp and remove the air cleaner cap sub-assembly.

  6. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  8. DISCONNECT NO. 1 AIR CLEANER INLET


    1. A004UDY

      Remove the bolt and disconnect the No. 1 air cleaner inlet.

      Note

      Slide the No. 1 air cleaner inlet to ensure a space for the removal and installation of the ECM installation bolt.

  9. REMOVE ECM


    1. A004SMJ

      Push in the locks on the 2 levers, raise the levers and disconnect the 2 ECM connectors.

      Text in Illustration
      A004NPW Push

      Note

      After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.

    2. A004QPJ

      Remove the 2 bolts and ECM with bracket.

    3. A004SX8

      Remove the 2 screws and No. 1 ECM bracket.

    4. Remove the 2 screws and No. 2 ECM bracket.