AIR FUEL RATIO SENSOR(for Sensor 2) INSTALLATION

PROCEDURE


  1. INSTALL AIR FUEL RATIO SENSOR


    1. A004OH5E01
      Text in Illustration
      *a Fulcrum Length

      Using SST, install the air fuel ratio sensor.

      SST
      09224-00011
      Torque:
      Specified tightening torque
      50 N*m  { 510 kgf*cm, 37 ft.*lbf }

      Note

      If an air fuel ratio sensor has been struck or dropped, replace it.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench Click here.

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)): 45 N*m (456 kgf*cm, 33 ft.*lbf).

    2. Attach the 2 clamps.

    3. A004PQ3E03
      Text in Illustration
      *1 Air Fuel Ratio Sensor Connector
      *2 Bracket
      *a 1.5 mm (0.0591 in.) or less

      Lower the air fuel ratio sensor connector to the position shown in the illustration and connect the air fuel ratio sensor connector.

  2. INSPECT FOR EXHAUST GAS LEAK

    Click here

  3. INSTALL NO. 2 ENGINE UNDER COVER

    Click here

  4. PERFORM INITIALIZATION

    Click here