TILT AND TELESCOPIC MANUAL SWITCH REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE LOWER NO. 2 STEERING COLUMN COVER


    1. A004MQH

      Detach the 4 claws and remove the lower No. 2 steering column cover.

  2. REMOVE STEERING COLUMN COVER

    Note

    Removing the steering column cover in an incorrect order will cause the steering column cover to break.


    1. A004NZD

      Push the right and left sides of the lower steering column cover and detach the 4 claws.

    2. A004O2T

      Insert fingers into the service hole of the lower steering column cover to detach the claw.

      Tech Tips

      Spread the claw to detach it.

    3. A004NPY

      Detach the 2 claws and remove the lower steering column cover.

    4. A004TOY

      Detach the claw and 2 pins, and remove the upper steering column cover.

  3. REMOVE TILT AND TELESCOPIC SWITCH

    A004OU3

    1. Disconnect the switch connector.

    2. Using a screwdriver, detach the claw and remove the switch.

      Note

      Pushing on the claw too hard will break the claw.

      Tech Tips

      Tape the screwdriver tip before use.