REAR BRAKE FLEXIBLE HOSE INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The following procedure is for the LH side.

Note


  • Because the left and right rear flexible hoses are not interchangeable, verify the part number when installing the flexible hoses.

  • If the hoses are to be reused, connect them after checking the identification marks placed when each hose is removed.

PROCEDURE


  1. INSTALL REAR FLEXIBLE HOSE


    1. Install the rear flexible hose with a new clip.

      Note

      Make sure the clip is completely pushed in.

    2. A004NFK

      Using a union nut wrench, connect the brake line to the rear flexible hose while holding the rear flexible hose with a wrench.

      Torque:
      15 N*m  { 155 kgf*cm, 11 ft.*lbf }

      Note


      • Do not kink or damage the brake line.

      • Do not allow any foreign matter such as dirt and dust to enter the brake line.

      • Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Click here.

    3. Connect the rear flexible hose to the rear axle beam with the bolt.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }
    4. A004TB8

      Install a new gasket and connect the rear flexible hose to the rear disc brake cylinder assembly with a new union bolt.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }

  2. FILL RESERVOIR WITH BRAKE FLUID

    Click here

  3. BLEED BRAKE LINE

    Click here

  4. BLEED CLUTCH LINE (for 1AD-FTV)

    Click here

  5. BLEED CLUTCH LINE (for 2AD-FHV)

    Click here

  6. BLEED CLUTCH LINE (for 2AD-FTV)

    Click here

  7. INSPECT FOR BRAKE FLUID LEAK

  8. INSTALL CENTER COWL TOP VENTILATOR LOUVER

    Click here

  9. INSPECT BRAKE FLUID LEVEL

    Click here

  10. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }