BRAKE MASTER CYLINDER REMOVAL

CAUTION / NOTICE / HINT

Note

Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster.

PROCEDURE


  1. REMOVE FUEL FILTER ELEMENT ASSEMBLY


    1. for 1AD-FTV:

      Remove the fuel filter element assembly Click here.

    2. for 2AD-FHV:

      Remove the fuel filter element assembly Click here.

    3. for 2AD-FTV:

      Remove the fuel filter element assembly Click here.

  2. REMOVE WINDSHIELD WIPER MOTOR AND LINK


    1. Remove the windshield wiper motor and link Click here.

  3. REMOVE INNER COWL TOP PANEL SUB-ASSEMBLY (for 1AD-FTV)

    Click here

  4. REMOVE INNER COWL TOP PANEL SUB-ASSEMBLY (for 2AD-FHV)

    Click here

  5. REMOVE INNER COWL TOP PANEL SUB-ASSEMBLY (for 2AD-FTV)

    Click here

  6. DRAIN BRAKE FLUID

    Note

    Wash off brake fluid immediately if it comes in contact with any painted surface.

  7. REMOVE BRAKE ACTUATOR ASSEMBLY (for LHD)


    1. Remove the brake actuator assembly Click here.

  8. DISCONNECT CLUTCH TUBE


    1. A004MP6E04
      Text in Illustration
      *A for LHD
      *B for RHD

      Slide the clip and disconnect the clutch tube.

  9. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY


    1. A004PNIE04
      Text in Illustration
      *A for LHD
      *B for RHD

      Disconnect the connector and detach the clamp.

    2. A004PWNE03
      Text in Illustration
      *A for LHD
      *B for RHD

      Using a union nut wrench, disconnect the 2 brake lines from the brake master cylinder sub-assembly.

    3. A004QBFE03
      Text in Illustration
      *1 Piston

      Remove the 2 nuts and brake master cylinder sub-assembly.

      Note


      • The master cylinder requires careful handling. Do not allow the master cylinder to receive any impact, such as from being dropped. Do not reuse a master cylinder that has been dropped.

      • Do not strike or pinch the master cylinder piston, and do not cause any damage to the master cylinder piston by any other means.

      • When installing the master cylinder to the brake booster, or when removing the master cylinder from the brake booster, make sure that the master cylinder is kept horizontal or with its tip facing downward (the piston faces upward) to prevent the master cylinder piston from falling out.

      • Do not allow any foreign objects to contaminate the master cylinder piston. If a foreign object gets on the piston, remove it by using a piece of cloth and then apply an even layer of lithium soap base glycol grease around the circumference (sliding part) of the piston.

      • Do not use any other type of grease or fluid.

      • Be careful not to damage the brake tubes.

    4. Remove the O-ring from the brake master cylinder sub-assembly.