STEERING ANGLE SENSOR REMOVAL

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read the "PRECAUTION" thoroughly before servicing Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  4. REMOVE LOWER STEERING COLUMN COVER

    Click here

  5. REMOVE UPPER STEERING COLUMN COVER

    Click here

  6. REMOVE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

    Note


    • Do not replace the spiral with sensor cable sub-assembly with the battery connected and the ignition switch ON.

    • Do not rotate the spiral with sensor cable sub-assembly with the battery connected and the ignition switch ON.

    • When rotating the spiral with sensor cable sub-assembly to check the operation of the sub-assembly (checking for abnormal noise, checking the Data List, etc.), make sure to perform the inspection with the steering wheel assembly installed.

    • Do not remove the steering angle sensor from the spiral cable.


    1. A004O94E01
      Text in Illustration
      *1 Slider
      A004P4E Slide

      Slide the airbag connector slider as shown in the illustration and disconnect the airbag connector from the spiral with cable sensor sub-assembly.

    2. Disconnect each connector from the spiral with sensor cable sub-assembly.

    3. A004NQV

      Detach the 3 claws and remove the spiral with sensor cable sub-assembly.