REAR SPEED SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH (SKID CONTROL SENSOR)


    1. Install the rear axle hub and bearing LH Click here.

  2. INSTALL SKID CONTROL SENSOR WIRE

    Note

    To prevent interference with other parts, do not twist the painted line areas of the sensor wire when installing it.


    1. A004N3C

      Connect the skid control sensor wire connector to the skid control sensor.

    2. Attach the sensor clamp.

      Note

      Do not twist the sensor wire when installing the clamp.

    3. A004UDC

      Install the sensor clamp with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      Do not twist the sensor wire when installing the clamp.

    4. A004OPE

      Install the sensor clamp with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      Do not twist the sensor wire when installing the clamp.

    5. A004RNHE08
      Text in Illustration
      *1 Grommet
      *2 Band Clamp
      *3 Connector
      *a Inside of Vehicle

      Insert the connector and grommet into the inside of the vehicle through the hole in the wheel house.

      Note

      Make sure the band clamp remains on the outside of the vehicle.

    6. A004ONJE10
      Text in Illustration
      *a Outside of Vehicle
      *b 30°

      Hold the grommet and pull it toward the outside of the vehicle. Then fix the grommet in place so that it is not tilted.

      Note


      • When pulling out the grommet, do not grip the sensor wire.

      • Fix the grommet in place within the range shown in the illustration.

    7. Connect the skid control sensor wire connector to the vehicle side connector on the rear floor.

  3. INSTALL REAR SEAT ASSEMBLY


    1. for Sedan:

      Install the rear seat assembly Click here.

    2. for Wagon:

      Install the rear seat assembly Click here.

  4. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  5. CHECK SPEED SENSOR SIGNAL


    1. Check the speed sensor signal Click here.