CRANKSHAFT POSITION SENSOR INSTALLATION

PROCEDURE

1. INSTALL CRANKSHAFT POSITION SENSOR

   
   

   1. Apply a light coat of engine oil to the O-ring of the sensor.

   2. Install the sensor with the bolt.

      Torque:

      8.8 N*m  { 90 kgf*cm, 78 in.*lbf }

   3. Install the harness clamp bracket with the bolt.

      Torque:

      8.8 N*m  { 90 kgf*cm, 78 in.*lbf }

   4. Attach the sensor wire harness clamp.

   5. Connect the sensor connector to the bracket.

   6. Connect the sensor connector.

2. INSTALL GENERATOR ASSEMBLY

   Click here