ECM REMOVAL

PROCEDURE

1. PERFORM REGISTRATION

   
   

   1. Perform learning values save.

      
      

      • for DPF: Click here

      • for CCo: Click here

2. PRECAUTION

   Note

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

4. REMOVE NO. 1 ENGINE COVER

   Click here

5. REMOVE RADIATOR SUPPORT OPENING COVER

   Click here

6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

   Click here

7. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

   Click here

9. REMOVE NO. 1 AIR CLEANER INLET

   
   

   1. 

      Remove the clip and No. 1 air cleaner inlet.

10. REMOVE NO. 2 AIR CLEANER INLET

    
    

    1. 

       Remove the bolt and No. 2 air cleaner inlet

11. REMOVE ECM

    
    

    1. Disconnect the 2 ECM connectors.

       
       

       1. 

          Raise the 2 levers while pushing the locks on the levers and disconnect the 2 ECM connectors.

          Note

          After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.

    2. 

       Remove the 2 bolts and ECM with bracket.

    3. 

       Remove the 4 screws and 2 ECM brackets.