REAR DOOR BELT MOULDING(for Sedan) REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION (w/ Power Window)

   Note

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Power Window)

   Note

   When disconnecting the cable some systems need to be initialized after the cable is reconnected Click here.

3. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

   Click here

4. REMOVE REAR DOOR REGULATOR INSIDE HANDLE PLATE (w/o Power Window)

   Click here

5. REMOVE REAR DOOR NO. 1 STIFFENER CUSHION

   Click here

6. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH

   Click here

7. REMOVE DOOR ASSIST GRIP COVER LH

   Click here

8. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)

   Click here

9. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

   Click here

10. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH

    Click here

11. REMOVE REAR DOOR SERVICE HOLE COVER LH

    Click here

12. REMOVE REAR DOOR GLASS RUN LH

    Click here

13. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

    Click here

14. REMOVE REAR DOOR QUARTER WINDOW GLASS LH

    Click here

15. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

16. REMOVE REAR DOOR BELT MOULDING LH

    

    Text in Illustration

    *1	Protective Tape
    *2	Claw A

    
    

    1. Put protective tape around the rear door belt moulding.

    2. Detach the 7 claws and remove the rear door belt moulding.

       Tech Tips

       If either of the claws labeled A is damaged, replace the rear door belt moulding with a new one.