INTEGRATION RELAY ON-VEHICLE INSPECTION

PROCEDURE


  1. REMOVE NO. 1 RELAY BLOCK COVER

  2. INSPECT INTEGRATION NO.1 RELAY

    A0055KOE06
    Text in Illustration
    *1 Protective Tape

    1. Using a screwdriver, detach the 2 claws and disconnect the integration relay from the engine room junction block.

      Tech Tips

      Tape the screwdriver tip before use.

    2. A005593E02
      Text in Illustration
      *1

      Component with harness connected

      (Integration Relay)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1A-8 - 1C-1 Battery voltage is not applied to terminals 1A-6 and 1A-7 10 kΩ or higher
      1A-8 - 1A-5
      1A-8 - 1C-1 Battery voltage is applied to terminals 1A-6 and 1A-7 Below 1 Ω
      1A-8 - 1A-5

      If the result is not as specified, replace the integration relay.

    3. Attach the 2 claws to install the integration relay to the engine room junction block.

  3. INSTALL NO. 1 RELAY BLOCK COVER