CAUTION / NOTICE / HINT
Tech Tips
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
REMOVE REAR BENCH TYPE SEAT CUSHION ASSEMBLY
REMOVE REAR SIDE SEATBACK ASSEMBLY LH
REMOVE REAR SIDE SEATBACK ASSEMBLY RH
REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
REMOVE ROOM PARTITION NET ASSEMBLY (w/ Partition Net)
REMOVE LOWER DECK TRIM SIDE BOARD LH (w/ Partition Board)
REMOVE LOWER DECK TRIM SIDE BOARD RH (w/ Partition Board)
REMOVE DECK BOARD ASSEMBLY
REMOVE DECK BOARD SUB-ASSEMBLY
REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY
REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY
REMOVE REAR DECK FLOOR BOX
REMOVE FLOOR SIDE RAIL LH (w/ Deck Rail)
REMOVE FLOOR SIDE RAIL RH (w/ Deck Rail)
REMOVE NO. 2 DECK SIDE TRIM COVER (w/o Deck Rail)
REMOVE NO. 1 DECK SIDE TRIM COVER (w/o Deck Rail)
REMOVE NO. 6 DECK SIDE TRIM COVER (w/o Deck Rail)
REMOVE NO. 5 DECK SIDE TRIM COVER (w/o Deck Rail)
REMOVE ROPE HOOK ASSEMBLY (w/o Deck Rail)
REMOVE DECK FLOOR BOX LH
REMOVE DECK FLOOR BOX RH
REMOVE REAR FLOOR FINISH PLATE
REMOVE FRONT DECK FLOOR BOX
REMOVE REAR DOOR SCUFF PLATE LH
REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
REMOVE BACK DOOR WEATHERSTRIP
REMOVE INNER ROOF SIDE GARNISH CAP LH
REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
REMOVE REAR COMBINATION LIGHT LENS AND BODY LH
| *1 | Protective Tape |
Put protective tape around the rear combination light lens and body LH.
Disconnect the connector.
Remove the 3 nuts.
Detach the clip and remove the rear combination light lens and body LH.
REMOVE REAR COMBINATION LIGHT BODY GASKET LH
Remove the a rear combination light body gasket LH.
Note
Be sure to remove the gasket completely from the body.
REMOVE REAR TURN SIGNAL LIGHT BULB
Turn the rear combination light bulb holder LH in the direction indicated by the arrow in the illustration and remove the socket.
Remove the rear turn signal light bulb from the rear combination light bulb holder LH.
REMOVE REAR COMBINATION LIGHT BULB HOLDER LH
Detach the clamp and 2 claws.
Detach the guide and remove the rear combination light bulb holder LH.
Disconnect the connector.