RAIN SENSOR INSTALLATION

PROCEDURE

1. INSTALL RAIN SENSOR TAPE

   Tech Tips

   The rain sensor tape is reusable. Only replace the tape if it is damaged or contaminated.

   
   

   1. Clean the rain sensor sensing portion with a piece of cloth.

   2. 

      Peel off the smaller release sheet, and then attach the rain sensor tape to the rain sensor sensing portion as shown in the illustration.

      Standard Clearance

      Area	Measurement
      A	18.0 mm (0.709 in.)
      B	6.0 mm (0.236 in.)

      Tech Tips

      Use your fingers to push out any air bubbles from under the tape.

2. INSTALL RAIN SENSOR

   
   

   1. Clean the windshield glass with a piece of cloth, etc.

      Note

      
      

      • Make sure that there is no rain sensor tape residue remaining on the windshield glass. If there is, remove the residue.

      • If there is any rain sensor tape residue remaining on the windshield glass, replace the tape.

   2. When installing a new rain sensor or replacing the rain sensor tape:

      Peel off the release sheet.

      Note

      Do not touch the silicon coated surfaces.

   3. 

      Connect the connector.

      Note

      Do not touch the silicon coated or glass surfaces.

   4. 

      Attach the 2 claws to install the rain sensor.

      Note

      Make sure that there are no air bubbles between the silicon coated and windshield glass.

3. INSTALL NO. 2 RAIN SENSOR COVER

   
   

   1. 

      Using a screwdriver, attach the 2 claws to install the No. 2 rain sensor cover.

4. INSTALL NO. 1 RAIN SENSOR COVER

   
   

   1. 

      Attach the 3 claws to install the No. 1 rain sensor cover.