REAR WIPER MOTOR(for Wagon) INSTALLATION

PROCEDURE

INSTALL REAR WIPER MOTOR GROMMET
1. Text in Illustration
  
  *1 MP grease
  
  Apply MP grease to the entire surface of the wiper motor grommet lip.
  
  Tech Tips
  
  Make sure that the hole does not get clogged with grease and the grooves on the lip are filled with grease.
2. Text in Illustration
  
  *1 Position Mark
  
  Install the rear wiper motor grommet with the position mark facing upward as shown in the illustration.
INSTALL REAR WIPER MOTOR ASSEMBLY
1. Temporarily install the rear wiper motor assembly with the 3 bolts.
2. Tighten the 3 bolts.
  
  Torque:
  
  5.5 N*m { 56 kgf*cm, 49 in.*lbf }
3. Connect the connector.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

Text in Illustration
*1	MP grease

Text in Illustration
*1	Position Mark

INSTALL REAR WIPER ARM

Operate the rear wiper, and stop the rear wiper motor at the automatic stop position.

Text in Illustration
*1	Wiper Arm Pivot Serrations
*2	Wiper Pivot Serrations

Clean the serrations.

Text in Illustration

*1 Defogger Line

Set the head of the blade on the defogger line.
Install the rear wiper arm with the nut.

Torque:

5.5 N*m { 56 kgf*cm, 49 in.*lbf }
Close the wiper arm head cap.