REAR WIPER MOTOR(for Wagon) INSPECTION

PROCEDURE


  1. INSPECT REAR WIPER MOTOR ASSEMBLY

    A00594NE25
    Text in Illustration
    *1

    Component without harness connected

    (Rear Wiper Motor Assembly)

    1. Check the wiper operation.


      1. Connect the battery's positive (+) lead to terminal 4 (+B), and the negative (-) lead to terminal 3 (LS) and terminal 5 (E), and check that the motor operates.

        OK
        Motor operates.

        If the result is not as specified, replace the motor assembly.

    2. Check the INT operation.


      1. Connect the battery's positive (+) lead to terminal 4 (+B), and the negative (-) lead to terminal 2 (C1) and terminal 5 (E), and check that the motor operates.

        OK
        Motor operates.

        If the result is not as specified, replace the motor assembly.

    3. Check the automatic stop operation.


      1. Place matchmarks on the motor shaft and housing.

      2. Connect the battery's positive (+) lead to terminal 4 (+B), and the negative (-) lead to terminal 3 (LS) and terminal 5 (E). With the motor rotating, disconnect terminal 3 (LS) to stop the wiper motor operation at any position other than where the matchmarks align.

      3. A0058DZE01
        Text in Illustration
        *1 Matchmarks

        Check that the motor stops automatically at the position where the matchmarks align.

        OK
        Motor stops automatically at the position where the matchmarks align.

        If the result is not as specified, replace the rear wiper motor assembly.