REAR DOOR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


    1. A00547C

      Insert clip remover between the plate and trim board.

    2. Turn the handle counterclockwise to remove the snap ring and handle.

  4. REMOVE REAR DOOR REGULATOR INSIDE HANDLE PLATE (w/o Power Window)


    1. Remove the inside handle plate.

  5. REMOVE REAR DOOR NO. 1 STIFFENER CUSHION


    1. A0054LS

      Remove the stiffener cushion.

  6. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH


    1. A0057II

      Using moulding remover A, detach the 3 claws and remove the bezel plug.

  7. REMOVE DOOR ASSIST GRIP COVER LH


    1. A00575Z

      Using moulding remover A, detach the 10 claws and remove the assist grip cover.

  8. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)


    1. A0053VO

      Using moulding remover A, detach the 6 claws and the clip.

    2. Disconnect the connector and remove the rear power window regulator switch assembly with rear door armrest base panel.

  9. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A0054CP

      Remove the 3 screws.

    2. Using a clip remover, detach the 8 clips.

    3. A00551SE02
      Text in Illustration
      *1 w/ Rear Door Sunshade
      *2 w/o Rear Door Sunshade

      Pull out the rear door trim board in the direction indicated by the arrow.

    4. for 11 Speakers:


      1. Disconnect the connector.

    5. A0056RB

      Disconnect the 2 cables from the inside handle.

  10. REMOVE REAR NO. 2 SPEAKER ASSEMBLY (for 11 Speakers)

    Click here

  11. REMOVE REAR DOOR SPEAKER GRILLE SUB-ASSEMBLY (for 11 Speakers)


    1. A00583Q

      Detach the 3 claws and remove the rear door speaker grille sub-assembly.

  12. REMOVE REAR NO. 1 SPEAKER ASSEMBLY

    Click here

  13. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH


    1. A0053FL

      Remove the inner glass weatherstrip by pulling it upward in the direction indicated by the arrow in the illustration.

  14. REMOVE REAR DOOR FRAME GARNISH LH


    1. A0054X6E02
      *1 for Sedan:
      *2 for Wagon:

      Detach the 2 clips.

    2. Detach the claws and remove the rear door frame garnish.

  15. REMOVE REAR DOOR SERVICE HOLE COVER LH


    1. A005445

      Disconnect connector and remove the service hole cover.

      Tech Tips

      Remove the remaining tape on the door.

  16. REMOVE REAR DOOR GLASS RUN LH


    1. A0059ACE01
      *1 for Sedan:
      *2 for Wagon:

      Remove the rear door glass run.

  17. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH


    1. A0058SQE01
      *1 for Sedan:
      *2 for Wagon:

      Remove the screw.

    2. Remove the 2 bolts and rear door window division bar sub-assembly.

  18. REMOVE REAR DOOR QUARTER WINDOW GLASS LH


    1. A0055WIE01
      *1 for Sedan:
      *2 for Wagon:

      Remove the rear door quarter window glass and rear door quarter window weatherstrip as a unit as shown in the illustration.

  19. REMOVE REAR DOOR QUARTER WINDOW WEATHERSTRIP LH


    1. A0054ZPE01
      *1 for Sedan:
      *2 for Wagon:

      Remove the rear door quarter window weatherstrip from the rear door quarter window glass.

  20. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH


    1. A0057CM

      Remove the rear door glass sub-assembly from the rear door window regulator sub-assembly as shown in the illustration.

      Note

      Do not damage the door glass.

  21. REMOVE REAR DOOR GLASS CHANNEL FILLER


    1. A0057E3

      Using a screwdriver, remove the glass channel.

      Note

      Be careful not to damage the glass.

    2. Remove the rear door glass channel filler.

  22. REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY LH


    1. w/ Power Window:


      1. A0052ANE01
        Text in Illustration
        *1 Temporary Bolt

        Disconnect the connector.

      2. Loosen the temporary bolt.

        Note

        Do not remove the temporary bolt. If the temporary bolt is removed, the rear door window regulator may fall and cause damage.

      3. Remove the 3 bolts.

      4. Remove the rear door window regulator assembly.

      5. Remove the temporary bolt from the rear door window regulator.

    2. A0057WO

      w/o Power Window:

      Remove the 3 bolts and regulator.

      Note

      Be careful when removing the bolts as the regulator may fall and become damaged.

  23. REMOVE REAR DOOR WITH MOTOR LOCK ASSEMBLY LH

    Click here

  24. REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH


    1. A0058OK

      Using a screwdriver, detach the claw.

      Tech Tips

      Tape the screwdriver tip before use.

    2. A00538G

      Remove the rear door remote control cable.

  25. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH


    1. A005529

      Using a screwdriver, detach the 3 claws.

      Tech Tips

      Tape the screwdriver tip before use.

    2. A0053IDE01
      *1 w/o Double Locking System:
      *2 w/ Double Locking System:

      Remove the rear door inside locking cable.

  26. REMOVE REAR DOOR OUTSIDE HANDLE COVER LH


    1. A005488

      Using a T30 ''TORX'' socket, loosen the screw and detach the claw to remove the outside handle cover.

  27. REMOVE REAR DOOR OUTSIDE HANDLE ASSEMBLY LH


    1. A00542FE05
      Text in Illustration
      *1 Holder

      Detach the holder as shown in the illustration.

    2. A0052X7

      Remove the handle by sliding and pulling it in the direction indicated by the arrow in the illustration.

  28. REMOVE REAR DOOR FRONT OUTSIDE HANDLE PAD


    1. A0056SJ

      Detach the 3 claws and remove the pad.

  29. REMOVE REAR DOOR REAR OUTSIDE HANDLE PAD


    1. A0058QB

      Detach the 2 claws and remove the pad.

  30. REMOVE REAR DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY LH


    1. A0057QN

      Using a T30 ''TORX'' socket, loosen the screw.

    2. Slide the outside handle frame to remove it.

      Tech Tips

      Remove the outside handle frame through the service hole.

  31. REMOVE REAR DOOR INSIDE PANEL REINFORCE SUB-ASSEMBLY LH


    1. A0054H5

      Remove the 4 bolts and rear door inside panel reinforce sub-assembly.

  32. REMOVE REAR DOOR CHECK ASSEMBLY LH


    1. A0058R9

      Remove the bolt, 2 nuts and door check.

      Tech Tips

      Remove the door check through the service hole.

      Note

      Be careful when removing the bolt and nuts as the door check may fall and become damaged.

  33. REMOVE REAR DOOR WEATHERSTRIP LH


    1. A0055O0

      for Sedan:


      1. Detach the 19 clips and guide, and remove the rear door weatherstrip.

      2. Remove the double-sided tape.

    2. A00549P

      for Wagon:

      Detach the 18 clips and remove the rear door weatherstrip.

  34. REMOVE REAR DOOR WINDOW FRAME MOULDING SUB-ASSEMBLY LH

    Click here

  35. REMOVE REAR DOOR MOULDING SUB-ASSEMBLY OUTSIDE LH (for Sedan)

    Click here

  36. REMOVE REAR DOOR UPPER WINDOW FRAME MOULDING LH (for Wagon)

    Click here

  37. REMOVE REAR DOOR REAR WINDOW FRAME MOULDING LH (for Wagon)

    Click here

  38. REMOVE REAR DOOR NO. 2 WEATHERSTRIP LH


    1. Detach the 7 clips and remove the rear door No. 2 weatherstrip.