POWER WINDOW REGULATOR MOTOR(for Front Door) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  4. REMOVE ASSIST GRIP COVER LH

    Click here

  5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

  6. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  7. REMOVE FRONT DOOR NO. 1 STIFFENER CUSHION

    Click here

  8. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  9. REMOVE COURTESY LIGHT ASSEMBLY

    Click here

  10. REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY LH

    Click here

  11. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  12. REMOVE DOOR FRAME GARNISH LH

    Click here

  13. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

    Click here

  14. REMOVE FRONT DOOR SERVICE HOLE COVER LH

    Click here

  15. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

  16. REMOVE FRONT DOOR WINDOW REGULATOR ASSEMBLY LH


    1. Disconnect the connector.

    2. A00547NE02
      Text in Illustration
      *1 Temporary Bolt

      Loosen the temporary bolt.

      Note

      Do not remove the temporary bolt. If the temporary bolt is removed, the front door window regulator may fall and cause damage.

    3. Remove the 5 bolts.

    4. Remove the front door window regulator assembly.

    5. Remove the temporary bolt from the front door window regulator assembly.