DESCRIPTION
When the engine is started, the generator assembly turns and a pulsed voltage signal is generated.
This signal is used by the air conditioning amplifier assembly.
The signal expressing the amount of output from the generator assembly is one element of PTC heater control.
WIRING DIAGRAM
| *a | Generator Assembly |
| *b | Air Conditioning Amplifier Assembly |
PROCEDURE
CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - GENERATOR)
Disconnect the D47 amplifier connector.
Disconnect the B16 generator connector.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | |||||||||
|---|---|---|---|---|---|---|---|---|---|
|
| *1 | Rear view of wire harness connector (to Air Conditioning Amplifier Assembly) |
| *2 | Front view of wire harness connector (to Generator Assembly) |
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
|
CHECK MODEL
Check the engine model.
| Result | Proceed to |
|---|---|
| 3ZR-FE | A |
| 1ZR-FAE, 2ZR-FAE, 3ZR-FAE | B |
| B |
|
INSPECT GENERATOR ASSEMBLY Click here |
| A |
|
INSPECT GENERATOR ASSEMBLY
for 3ZR-FE:
Inspect the generator assembly Click here.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for 3ZR-FE) | B |
| A |
|
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here |
| B |
|
REPLACE GENERATOR ASSEMBLY Click here |
INSPECT GENERATOR ASSEMBLY
for 1ZR-FAE:
Inspect the generator assembly Click here.
for 2ZR-FAE:
Inspect the generator assembly Click here.
for 3ZR-FAE:
Inspect the generator assembly Click here.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for 1ZR-FAE) | B |
| NG (for 2ZR-FAE) | C |
| NG (for 3ZR-FAE) | D |
| A |
|
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here |
| B |
|
REPLACE GENERATOR ASSEMBLY Click here |
| C |
|
REPLACE GENERATOR ASSEMBLY Click here |
| D |
|
REPLACE GENERATOR ASSEMBLY Click here |