DATA LIST
Tech Tips
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Note
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body / Main Body / Data List.
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Key Unlock Warning SW | Unlock warning switch signal / ON or OFF | ON: Key in ignition key cylinder OFF: No key in ignition key cylinder |
- |
| ACC SW | Ignition switch signal / ON or OFF | ON: Ignition switch ACC OFF: Ignition switch off |
"ON" is also displayed for this item when the ignition switch is ON. |
| IG SW | Ignition switch signal / ON or OFF | ON: Ignition switch ON OFF: Ignition switch ACC or off |
"OFF" is also displayed for this item when the engine switch is ACC. |
| D Door Courtesy SW | Driver side door courtesy light switch signal / ON or OFF | ON: Driver side door courtesy light switch on OFF: Driver side door courtesy light switch off |
- |
| P Door Courtesy SW | Front passenger side door courtesy light switch signal / ON or OFF | ON: Front passenger side door courtesy light switch on OFF: Front passenger side door courtesy light switch off |
- |
| RL Door Courtesy SW | Rear door courtesy light switch LH signal / ON or OFF | ON: Rear door courtesy light switch LH on OFF: Rear door courtesy light switch LH off |
- |
| RR Door Courtesy SW | Rear door courtesy light switch RH signal / ON or OFF | ON: Rear door courtesy light switch RH on OFF: Rear door courtesy light switch RH off |
- |
| Door Key SW-Lock | Door key switch lock signal / ON or OFF | ON: Door key switch turned to LOCK OFF: Door key switch not turned to LOCK |
- |
| Door Key SW-Unlock | Door key switch unlock signal / ON or OFF | ON: Door key switch turned to UNLOCK OFF: Door key switch not turned to UNLOCK |
- |
| D-Door Lock Pos SW | Driver side door unlock detection switch signal / ON or OFF | ON: Driver side door unlocked OFF: Driver side door locked |
- |
| P-Door Lock Pos SW | Front passenger side door unlock detection switch signal / ON or OFF | ON: Front passenger side door unlocked OFF: Front passenger side door locked |
- |
| I/L ON W/Door Key Unlock | Illumination function when door unlocked with door key cylinder / ON or OFF | Customize setting displayed | - |
| Lighting Time | Time before lights turn off after doors closed / 7.5s or 15s or 30s | Customize setting displayed | - |
| I/L when ACC OFF | Illumination function when ignition switch turned off / ON or OFF | Customize setting displayed | - |
| Room Light when Aprchd | Function which turns on the room lights when key is brought within vehicle exterior detection area | Customized setting displayed | w/ Entry and Start System |
| Inside Foot Light | Function which controls interior foot lights / ON or OFF | Customized setting displayed | w/ No. 1 Interior Illumination Light |
| Back Door Courtesy Switch | Back door courtesy light switch signal / ON or OFF | ON: Back door courtesy light switch on OFF: Back door courtesy light switch off |
for Wagon |
| Luggage Courtesy SW | Luggage compartment door courtesy light switch signal / ON or OFF | ON: Luggage compartment door courtesy light switch on OFF: Luggage compartment door courtesy light switch off |
for Sedan |
ACTIVE TEST
Tech Tips
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body / Main Body / Active Test.
According to the display on the GTS, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Illuminated Entry System | All parts illuminated by illuminated entry system | ON or OFF | - |
| Fr Foot Light | No. 1 interior illumination light | ON or OFF | w/ No. 1 Interior Illumination Light |
| Relay for Interior Light Auto Cut Function | DOME CUT relay | ON or OFF | - |