ENGINE HOOD COURTESY SWITCH INSPECTION

PROCEDURE


  1. INSPECT HOOD LOCK ASSEMBLY (ENGINE HOOD COURTESY SWITCH)


    1. A0056TGE01
      *1 Component without harness connected: (Hood Lock Assembly)
      *2 Unlock Position
      *3 Lock Position

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 2 Unlock position 10 kΩ or higher
      1 - 2 Lock position Below 1 Ω

      If the result is not as specified, replace the hood lock assembly.