ENTRY AND START SYSTEM(for Start Function), Diagnostic DTC:U0100, U0142, U0155

DTC Code DTC Name
U0100 Lost Communication with ECM / PCM
U0142 Lost Communication with Main Body ECU
U0155 Lost Communication with Combination Meter

DESCRIPTION

The power management control ECU receives information from 2 sources. It receives information via a direct line and via CAN communication line. If the information from these 2 sources is inconsistent, this DTC will be stored.

Tech Tips

When the power management control ECU is replaced with a new one and the cable is connected to the negative (-) battery terminal, the power source mode is reset to on (IG). When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.

DTC Code DTC Detection Condition Trouble Area
U0100 There is no communication from the ECM.

  • CAN communication system

  • ECM
U0142 There is no communication from the main body ECU.

  • CAN communication system

  • Main body ECU (Instrument panel junction block assembly)
U0155 There is no communication from the combination meter.

  • CAN communication system

  • Combination meter assembly

PROCEDURE


  1. CHECK FOR DTC


    1. Check for DTCs and note any codes that are output Click here.

    2. Clear the DTCs Click here.

    3. Recheck for DTCs Click here.

      OK
      CAN communication system DTC is not output.

      Tech Tips

      If CAN communication system DTC U0100, U0142 or U0155 and another DTC are output at the same time, perform troubleshooting for CAN communication system DTC first.


    OK

    USE SIMULATION METHOD TO CHECK Click here

    NG

    GO TO CAN COMMUNICATION SYSTEM (DIAGNOSIS SYSTEM) Click here