REAR DOOR LOCK REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION

   Note

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

3. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH

   Click here

4. REMOVE ASSIST GRIP COVER LH

   Click here

5. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

   Click here

6. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

   Click here

7. REMOVE REAR DOOR REGULATOR INSIDE HANDLE PLATE (w/o Power Window)

   Click here

8. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

   Click here

9. REMOVE REAR INNER DOOR GLASS WEATHERSTRIP LH

   Click here

10. REMOVE REAR DOOR SERVICE HOLE COVER LH

    Click here

11. REMOVE REAR DOOR GLASS RUN LH

    Click here

12. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

    Click here

13. REMOVE REAR DOOR QUARTER WINDOW GLASS LH

    Click here

14. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

15. REMOVE REAR DOOR LOCK ASSEMBLY LH

    
    

    1. 

       Detach the clamp.

    2. 

       *1	w/o Double Locking System:
       *2	w/ Double Locking System:

       Using a T30 "TORX" wrench, remove the 3 screws.

    3. Move the rear door lock assembly downward, pull the release plate out of the rear door outside handle frame, and remove the rear door lock assembly and cables as a unit.

    4. Remove the door lock wiring harness seal from the rear door lock assembly.

16. REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

    Click here

17. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH

    Click here