UNLOCK WARNING SWITCH INSPECTION

PROCEDURE


  1. INSPECT UNLOCK WARNING SWITCH ASSEMBLY

    A0053WPE16
    *1 Not Pushed
    *2 Pushed
    *3 Component without harness connected:(Unlock Warning Switch)

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      1 (UN+) - 2 (UN-) Not pushed 10 kΩ or higher
      Pushed Below 1 Ω

      If the result is not as specified, replace the unlock warning switch assembly.