INSTRUMENT PANEL SPEAKER(for 6 Speakers) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT PILLAR GARNISH LH (for Sedan)

    Click here

  4. REMOVE FRONT PILLAR GARNISH LH (for Wagon)

    Click here

  5. REMOVE NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY


    1. A005741

      Detach the claws and clips shown in the illustration on the bottom of the panel. Then, using the 2 claws on the side of the panel towards the front of the vehicle as pivot points, lift up the panel in the direction indicated by the arrow in the illustration until the speaker connector can be disconnected.

    2. A0059DE

      Disconnect the connector and remove the panel together with the speaker.

  6. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY


    1. A0053V6

      Detach the 3 claws and remove the front No. 2 speaker from the speaker panel.

      Note

      Do not touch the cone part of the speaker.