STEERING WHEEL INSTALLATION

PROCEDURE

INSTALL TRANSMISSION SHIFT SWITCH ASSEMBLY (w/ Shift Paddle Switch)
1. Text in Illustration
  
  *1 Shift Paddle Switch
  
  *2 Bracket
  
  Install the 2 shift paddle switches and 2 brackets with the 4 screws.
  
  Torque:
  
  1.7 N*m { 17 kgf*cm, 15 in.*lbf }
  
  CAUTION:
  
  Make sure that the brackets are securely installed.
2. Text in Illustration
  
  *1 Switch Wire
  
  Connect the 2 switch wire connectors to the shift paddle switches.
3. Install the connector to the steering wheel assembly.
4. Install the clamp to the steering wheel assembly.
INSTALL STEERING SHAKE DAMPER
1. Install the steering shake damper with the 2 screws.
  
  Torque:
  
  2.4 N*m { 24 kgf*cm, 21 in.*lbf }
INSTALL STEERING PAD SWITCH ASSEMBLY
1. Attach the 2 claws and 4 pins to install the steering pad switch.
2. Install the 2 screws.
  
  Torque:
  
  2.4 N*m { 24 kgf*cm, 21 in.*lbf }
3. Connect the connector.
INSTALL CRUISE CONTROL SWITCH WIRE (w/ Cruise Control System)
INSTALL CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)

Click here
PLACE FRONT WHEELS FACING STRAIGHT AHEAD
ADJUST SPIRAL CABLE

Click here
INSTALL STEERING WHEEL ASSEMBLY
1. Text in Illustration
  
  *1 Matchmark
  
  Align the matchmarks on the steering wheel assembly and steering main shaft.
2. Install the steering wheel assembly set nut.
  
  Torque:
  
  50 N*m { 510 kgf*cm, 37 ft.*lbf }
3. Connect the connectors to the spiral cable sub-assembly.
INSTALL STEERING PAD

Click here
INSTALL LOWER NO. 3 STEERING WHEEL COVER

Click here
INSTALL LOWER NO. 2 STEERING WHEEL COVER

Click here
INSPECT STEERING WHEEL CENTER POINT
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSPECT SRS WARNING LIGHT
1. Inspect the SRS warning light Click here.

Text in Illustration
*1	Shift Paddle Switch
*2	Bracket