FRONT SPEED SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL FRONT SPEED SENSOR LH

    Note

    To prevent interference with other parts, do not twist the painted line areas of the sensor wire when installing it.


    1. A0052JU

      Install the front speed sensor with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note


      • Keep the sensor tip and sensor installation hole free from foreign matter.

      • Firmly insert the sensor body into the knuckle before tightening the bolt.

      • After installing the sensor to the knuckle, make sure that there is no clearance between the sensor stay and knuckle. Also, make sure that no foreign matter is stuck between the parts.

      • To prevent interference between the sensor and magnetic rotor, do not rotate the sensor body during or after the insertion of the sensor body into the knuckle.

    2. A00540PE02

      Install the sensor clamp and attach the sensor clip as follows.


      1. Simultaneously perform the following: 1) hang the hook part of the sensor clamp (labeled A) on the flexible hose bracket (labeled D) and 2) insert the hook part of the sensor clamp (labeled B) into the flexible hose bracket (labeled C).

        Note

        Do not twist the sensor wire when installing the clamp.

      2. Install the sensor clamp to the flexible hose clamp and flexible hose bracket with the bolt.

        Torque:
        29 N*m  { 296 kgf*cm, 21 ft.*lbf }

      3. Attach the sensor clip to the hole in the lower absorber bracket.

    3. Install the sensor clamp and attach the sensor clip as follows.


      1. A00564A

        Set the sensor clamp on the side member, and then install the bolt.

        Torque:
        8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

        Note

        Do not twist the sensor wire when installing the clamp.

      2. Attach the sensor clip to the hole in the apron.

    4. A005455

      Connect the connector.

    5. Attach the connector clip to the hole in the cowl top side.

  2. INSTALL FRONT FENDER LINER LH

    Click here

  3. INSTALL FRONT WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  4. CHECK SPEED SENSOR SIGNAL


    1. Check the speed sensor signal Click here.