VEHICLE STABILITY CONTROL SYSTEM TS and CG Terminal Circuit

DESCRIPTION

In Test Mode (Signal Check), a malfunction in the speed sensor that cannot be detected when the vehicle is stopped can be detected while driving.

Transition to the sensor check mode can be performed by connecting terminals TS and CG of the DLC3 and turning the ignition switch from off to ON.

WIRING DIAGRAM

A0055MNE02

CAUTION / NOTICE / HINT

Note

When replacing the skid control ECU (brake actuator assembly), perform system variant learning and acceleration sensor zero point calibration Click here.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (TS of DLC3 - BRAKE ACTUATORASSEMBLY)


    1. Disconnect the A68 (for CVT) or A69 (for A/T or M/T) skid control ECU (brake actuator assembly) connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance (for CVT)
      Tester Connection Condition Specified Condition
      D8-12 (TS) - A68-27 (TS) Always Below 1 Ω
      D8-12 (TS) or A68-27 (TS) - Body ground Always 10 kΩ or higher
      Standard Resistance (for A/T or M/T)
      Tester Connection Condition Specified Condition
      D8-12 (TS) - A69-3 (TS) Always Below 1 Ω
      D8-12 (TS) or A69-3 (TS) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)


    1. A0056HYE01
      Text in Illustration
      *a Front view of DLC3

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      D8-4 (CG) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK HARNESS AND CONNECTOR (TS of DLC3 - BODY GROUND)


    1. A0053GQE01
      Text in Illustration
      *a Front view of DLC3

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      D8-12 (TS) - Body ground Always 10 kΩ or higher

      Tech Tips

      If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step Click here.


    OK

    REPLACE BRAKE ACTUATOR ASSEMBLY Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR