VEHICLE STABILITY CONTROL SYSTEM Slip Indicator Light does not Come ON

DESCRIPTION

Refer to Slip Indicator Light Remains ON Click here.

WIRING DIAGRAM

Refer to Slip Indicator Light Remains ON Click here.

CAUTION / NOTICE / HINT

PROCEDURE

1. CHECK CAN COMMUNICATION SYSTEM

   
   

   1. Check if a CAN communication system DTC is output Click here.

      Result
      Result Proceed to DTCs are not output. A DTCs are output. B

   
   

   B

   INSPECT CAN COMMUNICATION SYSTEM Click here

   A

2. PERFORM ACTIVE TEST USING GTS (SLIP INDICATOR LIGHT)

   
   

   1. Connect the GTS to the DLC3.

   2. Turn the ignition switch to ON.

   3. Select the Active Test on the GTS Click here.

      ABS/VSC/TRC

      Tester Display	Test Part	Control Range	Diagnostic Note
      Slip Indicator Light	Slip indicator light	Indicator light ON/OFF	Can be observed on the combination meter assembly Vehicle condition: Vehicle stopped

   4. Select the Data List on the GTS Click here.

      ABS/VSC/TRC

      Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
      Slip Indicator Light	Slip indicator light/ ON or OFF	ON: Indicator light on OFF: Indicator light off	-

   5. Check the operating condition of the slip indicator light when operating it using the GTS.

      Result
      Result Proceed to Slip Indicator Light in the Data List does not change using the Active Test. A Slip Indicator Light in the Data List turns ON/OFF using the Active Test. B

   
   

   A

   REPLACE BRAKE ACTUATOR ASSEMBLY Click here

   B

3. INSPECT COMBINATION METER ASSEMBLY

   
   

   1. Turn the ignition switch off.

   2. Perform an Active Test of the combination meter assembly using the GTS Click here.

   3. Check the combination meter assembly.

      OK
      The slip indicator light turns on or off in accordance with the Active Test operation.

   
   

   OK

   REPLACE BRAKE ACTUATOR ASSEMBLY Click here

   NG

   INSPECT METER / GAUGE SYSTEM Click here