VEHICLE STABILITY CONTROL SYSTEM DTC CHECK / CLEAR


  1. DTC CHECK/CLEAR (Using the Intelligent Tester)


    1. Check the DTCs.


      1. Turn the ignition switch off.

      2. Connect the intelligent tester to the DLC3.

      3. Turn the ignition switch to ON.

      4. Turn the intelligent tester on.

      5. Read the DTCs by following the prompts on the tester screen. Enter the following menus: Chassis / ABS/VSC/TRC / DTC.

      6. Check the details of the DTCs Click here.

    2. Clear the DTCs.


      1. Turn the ignition switch off.

      2. Connect the intelligent tester to the DLC3.

      3. Turn the ignition switch to ON.

      4. Turn the intelligent tester on.

      5. Operate the intelligent tester to clear the DTCs. Enter the following menus: Chassis / ABS/VSC/TRC / DTC / Clear.

  2. DTC CHECK/CLEAR (Using SST Check Wire)


    1. A0057GPE12
      Text in Illustration
      *1 Front view of DLC3

      Check the DTCs.


      1. Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

        SST
        09843-18040

      2. Turn the ignition switch to ON.

      3. Observe the blinking pattern of the ABS warning light and slip indicator light in order to identify the DTCs.

        If no code appears, inspect the TC and CG terminal circuit, and ABS warning light and slip indicator light circuits.

        Trouble Area See procedure
        TC and CG terminal circuit

        Click here

        ABS warning light circuit (Remains on)

        Click here

        ABS warning light circuit (Does not come on)

        Click here

        Slip indicator light circuit (Remains on)

        Click here

        Slip indicator light circuit (Does not come on)

        Click here

      4. As an example, the illustration below shows the blinking patterns of the normal system code, and trouble codes 11 and 21 for the ABS warning light.

        A0054HCE04

        Tech Tips

        The codes are explained in the Diagnostic Trouble Code Chart Click here.

      5. After completing the check, disconnect terminals 13 (TC) and 4 (CG) of the DLC3 to turn off the display.

        If 2 or more DTCs are stored at the same time, the DTCs will be displayed in ascending order.

    2. Clear the DTCs.


      1. A0057GPE12
        Text in Illustration
        *1 Front view of DLC3

        Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

        SST
        09843-18040

      2. Turn the ignition switch to ON.

      3. Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.

      4. Check that the ABS warning and slip indicator lights indicate a normal system code.

      5. Remove SST from the terminals of the DLC3.

  3. END OF DTC CHECK/CLEAR


    1. Turn the ignition switch to ON.

    2. Check that the ABS warning and slip indicator lights go off within approximately 3 seconds.