VEHICLE STABILITY CONTROL SYSTEM, Diagnostic DTC:C1428

DTC Code DTC Name
C1428 Motor Circuit Malfunction

DESCRIPTION

This DTC is stored when the skid control ECU (brake actuator assembly) judges that an abnormality occurred in the circuit used to operate the pump motor.

DTC No. DTC Detection Condition Trouble Area
C1428 A malfunction occurs in the pump motor circuit. Pump motor circuit

WIRING DIAGRAM

Refer to DTC C146C Click here.

CAUTION / NOTICE / HINT

Note


  • When replacing the skid control ECU (brake actuator assembly), perform system variant learning and acceleration sensor zero point calibration Click here.

  • Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE


  1. CHECK TERMINAL VOLTAGE (+BM TERMINAL)


    1. Turn the ignition switch off.

    2. A0058WJE02
      Text in Illustration
      *A for CVT
      *B for A/T or M/T
      *a

      Front view of wire harness connector

      (to Skid Control ECU (Brake Actuator Assembly))

      Make sure that there is no looseness at the locking part and the connecting part of the connector.

    3. Disconnect the A68 (for CVT) or A69 (for A/T or M/T) skid control ECU (brake actuator assembly) connector.

    4. Measure the voltage according to the value(s) in the table below.

      Standard Voltage (for CVT)
      Tester Connection Condition Specified Condition
      A68-1 (+BM) - Body ground Always 11 to 14 V
      Standard Voltage (for A/T or M/T)
      Tester Connection Condition Specified Condition
      A69-15 (+BM) - Body ground Always 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (+BM CIRCUIT)

    OK

  2. CHECK HARNESS AND CONNECTOR (GND2 TERMINAL)


    1. A005631E02
      Text in Illustration
      *A for CVT
      *B for A/T or M/T
      *a

      Front view of wire harness connector

      (to Skid Control ECU (Brake Actuator Assembly))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance (for CVT)
      Tester Connection Condition Specified Condition
      A68-13 (GND2) - Body ground Always Below 1 Ω
      Standard Resistance (for A/T or M/T)
      Tester Connection Condition Specified Condition
      A69-38 (GND2) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (GND2 CIRCUIT)

    OK

  3. RECONFIRM DTC


    1. Reconnect the A68 (for CVT) or A69 (for A/T or M/T) skid control ECU (brake actuator assembly) connector.

    2. Clear the DTCs Click here.

    3. Turn the ignition switch off.

    4. Start the engine.

    5. Perform a road test.

    6. Check if the same DTC is output Click here.

      Result
      Result Proceed to
      DTC C1428 is not output. A
      DTC C1428 is output. B

    A

    USE SIMULATION METHOD TO CHECK Click here

    B

    REPLACE BRAKE ACTUATOR ASSEMBLY Click here