TIRE AND WHEEL SYSTEM INSPECTION

PROCEDURE


  1. INSPECT TIRES


    1. Check the tires for wear and proper inflation pressure.

      Cold Tire Inflation Pressure
      Tire Size

      Front

      kPa (kgf/cm2, psi)

      Rear

      kPa (kgf/cm2, psi)
      205/60R16 92V - 240 (2.4, 35)*1 220 (2.2, 32)*1
      270 (2.7, 40)*2 250 (2.5, 37)*2
      for Algeria 250 (2.5, 37) 220 (2.2, 32)
      215/55R17 94W 240 (2.4, 35)*1 230 (2.3, 34)*1
      280 (2.8, 41)*2 270 (2.7, 40)*2
      225/45R18 91W 250 (2.5, 37)*1 240 (2.4, 35)*1
      290 (2.9, 43)*2 280 (2.8, 41)*2
      T145/70D17 106M 420 (4.2, 60)

      *1: For driving at under 160 km/h (100 mph)

      *2: For driving at over 160 km/h (100 mph)

    2. A0056JX

      Using a dial indicator, check the runout of the tires.

      Tire runout
      1.0 mm (0.0394 in.) or less

  2. ROTATE TIRE


    1. A0056ADE01
      Text in Illustration
      *a Front of the Vehicle
      *b Vehicle wheels and spare tire wheel are same type and without tire pressure warning system
      *c Vehicle wheels and spare tire wheel are not same type, there is no spare tire, or vehicle has tire pressure warning system

      Rotate the tires as shown in the illustration.

      Torque:
      103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  3. INSPECT WHEEL BALANCE


    1. A0057KFE01

      for Aluminum Wheel Type:

      Check and adjust the off-the-car balance.

      Maximum imbalance after adjustment
      8.0 g (0.0176 lb.)

      Note


      • Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.

      • Do not touch the sticking surface of the tape.

      • Adhere a sticking type balance weight to the flat surface (A) shown in the illustration.

        Width (A)
        25 mm (0.984 in.)

      • Push the balance weight firmly to adhere it to the position.

      • Do not reuse the balance weight.

      Tech Tips


      • The inner side balance weights should be installed by clipping them to the rim.

      • If necessary, check and adjust the on-the-car balance.

    2. A0053IA

      for Steel Wheel Type:

      Check and adjust the off-the-car balance.

      Maximum imbalance after adjustment
      8.0 g (0.0176 lb.)

      Tech Tips

      If necessary, check and adjust the on-the-car balance.

  4. INSPECT FRONT AXLE HUB BEARING

    Click here

  5. INSPECT REAR AXLE HUB BEARING

    Click here