REAR COIL SPRING INSTALLATION

PROCEDURE


  1. INSTALL REAR UPPER COIL SPRING INSULATOR LH

    A0054UAE07
    Text in Illustration
    *1 10 mm or less

    1. Install the rear upper coil spring insulator to the rear coil spring.

      Note

      Install the rear upper coil insulator so that the dimension between the stopper and upper end of the rear coil spring is 10 mm (0.394 in.) or less.

  2. INSTALL REAR LOWER COIL SPRING INSULATOR LH

  3. INSTALL REAR COIL SPRING LH

    A00584UE01

    1. Install the rear coil spring to the rear No. 2 suspension arm.

      Text in Illustration
      *1 End of Coil
      *2 Identification Mark

      Note


      • Install the rear coil spring so that the identification marks are positioned as shown in the illustration.

      • Install the rear coil spring so that its end is within the range shown in the illustration.

    2. A00579S

      Using a jack and wooden block, raise the vehicle gradually to install the rear No. 2 suspension arm to the rear axle carrier. Then temporarily install the bolt and nut.

  4. TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH

    Click here

  5. TEMPORARILY INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY LH

    Click here

  6. STABILIZE SUSPENSION

    Click here

  7. TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH

    Click here

  8. TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH


    1. A0059E4

      Tighten the bolts of the suspension arm.

      Torque:
      90 N*m  { 918 kgf*cm, 66 ft.*lbf }

      Note

      Since a stopper nut is used, tighten the bolt.

  9. INSTALL REAR STABILIZER LINK ASSEMBLY LH

    Click here

  10. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (for HID Headlight)

    Click here

  11. INSPECT AND ADJUST REAR WHEEL ALIGNMENT


    1. Inspect and adjust the rear wheel alignment Click here.

  12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  13. ADJUST HEADLIGHT ASSEMBLY


    1. for Halogen Headlight:

      Adjust the headlight assembly Click here.

    2. for HID Headlight:

      Adjust the headlight assembly Click here.