FRONT LOWER BALL JOINT INSTALLATION

PROCEDURE


  1. INSTALL FRONT LOWER BALL JOINT ASSEMBLY LH


    1. Secure the front axle assembly between aluminum plates in a vise.

      Note

      When using a vise, do not overtighten it.

    2. A0052GZ

      Install the front lower ball joint to the front axle assembly with the nut.

      Torque:
      133 N*m  { 1356 kgf*cm, 98 ft.*lbf }

    3. Install a new cotter pin.

      Note

      If the holes for the cotter pin are not aligned, align the holes by tightening the nut as necessary up to an additional 60°.

  2. INSTALL FRONT AXLE ASSEMBLY LH

    Click here

  3. CONNECT FRONT NO. 1 LOWER SUSPENSION ARM SUB-ASSEMBLY LH

    Click here

  4. CONNECT TIE ROD END SUB-ASSEMBLY LH

    Click here

  5. INSTALL FRONT DISC

    Click here

  6. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH

    Click here

  7. CONNECT FRONT FLEXIBLE HOSE

    Click here

  8. CONNECT FRONT SPEED SENSOR LH

    Click here

  9. INSTALL FRONT AXLE SHAFT NUT LH

    Click here

  10. INSTALL FRONT WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  11. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT


    1. Inspect and adjust the front wheel alignment Click here.

  12. CHECK SPEED SENSOR SIGNAL


    1. Check the speed sensor signal Click here.

  13. ADJUST HEADLIGHT ASSEMBLY


    1. for Halogen Headlight:

      Adjust the headlight assembly Click here.

    2. for LED Headlight:

      Adjust the headlight assembly Click here.