OIL PRESSURE SENSOR INSTALLATION

PROCEDURE


  1. INSTALL OIL PRESSURE SENSOR


    1. Apply Toyota Genuine CVT Fluid FE to the O-ring.

      Note

      If reusing the oil pressure sensor, check that the O-ring is not damaged.

    2. A0054NOE04
      Text in Illustration
      *a SST Fulcrum Length
      *b Torque Wrench Fulcrum Length

      Using SST, install the oil pressure sensor to the continuously variable transaxle assembly.

      SST
      09326-22011
      Torque:
      Specified tightening torque
      21 N*m  { 210 kgf*cm, 15 ft.*lbf }

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench Click here.

      • When using SST (fulcrum length of 50 mm (1.9685 in.)) + torque wrench (fulcrum length of 180 mm (7.0866 in.)): 16 N*m (164 kgf*cm, 12 ft.*lbf).

    3. Connect the oil pressure sensor connector.

  2. INSPECT FOR FLUID LEAK

  3. INSTALL REAR ENGINE UNDER COVER LH

    Click here

  4. INSTALL FRONT WHEEL LH

    Click here

  5. RESET MEMORY

    Click here